Kiwiliner 2000

IDEAL FOR KIWIFRUIT AND AVOCADOS WHERE A SHORTER AND LOWER PROFILE IS NEEDED

FEATURES AND OPTIONS

»» Low profile 2000 litre poly tank with fresh-water flushing tank standard
»» Options of 820mm front entry fan for kiwifruit or 920mm DSV fan with down-stream straightening vanes for tree crops
»» Stainless steel fan shroud – rugged and totally corrosion resistant (both fan models)
»» 2-speed gearbox for fan to allow for varying tree sizes
»» 170 L/min Brass pump standard – totally corrosion resistant – 200 L/min optional
»» Brass roll-over nozzle bodies to allow a choice of application rates
»» A choice of controller options from manual to fully automatic spray rate control
»» Fully hot-dipped galvanised chassis with rear and side bumpers

Description

Numerous build options available, contact us for more pricing options.

TANK

2000 litre main tank with separate 120 litre flush tank. 4 litre hand-wash tank.
Impact resistant polyethylene tank with UV-stabilised finish.
Calibrated sight gauge on front and side, flip-open filling lid with large basket strainer, separate chemical Chem induction probe and 1¼” drain valve. Deep sump design for total draining and liquid pick-up in sloping ground.

FAN OPTIONS

»» Kiwiliner – 820mm DSV Front-entry fan – stainless steel shroud and rear plate, downstream adjustable straightening vanes, NEW design glass-reinforced nylon polymer blades with adjustable pitch, 14 roll-over bodies per side, 2-speed oil-bath gearbox, centrifugal fan clutch. Optional second spray ring

PUMPS

ARBHS170 pump with brass heads and manifolds, oil-backed diaphragm type with chemical resistant diaphragms. 0-50 bar rated, 161 L/min (open-flow, zero pressure).
Optional ARBHS200 pump with brass heads and manifolds, oil-backed diaphragm type with chemical resistant diaphragms. 0-50 bar rated, 194 L/min (open-flow, zero pressure).

DRIVE (SH5AG)

Heavy duty PTO driveshaft comes with safety covers and quick release pins. Optional CV shaft.

CONTROLS

Remote mounted two-tap brass block controller with individual left/right shut-off, pressure adjustment and glycerine-filled gauge. Pressure and bypass regulator mounted on the pump.
Optional electric and auto rate controllers – see options

AGITATION

Supa-flo agitator and full bypass while filling with PRV in bypass mode

FILTRATION

Lid strainer, large suction filter. Optional pressure filters.

NOZZLES

Brass swing-over nozzle bodies, automatic shut-off type when in the half-turn position.
All units supplied with one set of ceramic hollow cone ALBUZ nozzles. Discs and cores optional.

CHASSIS

»»Hot-dipped galvanised, full-length with adjustable drawbar and single step, 6-stud wheel hubs, bumper bar comes with leaf guard. Side bumpers fitted standard for headland protection. Fixed axle standard; optional adjustable height and width axle.
»» Jockey wheel supplied on all models

WHEELS

»» Kiwiliner 2000 – steel rims, 27×9.5-15”

POWER REQUIRED – FAN ONLY

920mm DSV fan – minimum 37kW (50 hp) at PTO
20mm FE fan – minimum 34kW (45 hp) at PTO

DIMENSIONS

4.1m L (incl. drawbar) x 1.6m W x 1.38m H
Weight – approx 640kg Ca. Dry

SPRAY PUMP

HT-ARBHS200 200 L/min brass pump in lieu of ARBHS170 brass pump

DRIVE AND HITCH

HT-CV Wide angle constant velocity PTO shaft 

SPRAY CONTROL

HT-IS4021 Electric left/right 2-section on/off solenoids, electric pressure adjustment with integrated pressure filter and master switch with dump solenoid
HT-VISIO Visio spray monitor fitted – comes with flowmeter, sensor and cable to cab
HT-HV2400-SOL2 Croplands auto-rate controller, 2-section using on/off solenoid valves
HT-HV2400-SOL4 Croplands auto-rate controller, 4-section using on/off solenoid valves. Note – HT-SPLIT4SEC or HT-C218 must be added for this option 

CHEMICAL HANDLING

HT-RINSE Spray basket rinse kit
HT-KLC KLC-72 nozzle with manual dual feed taps 

FAN ACCESSORIES

B146.504.1070 In-line brass pressure filters (pair) {add extra set for twin rings on Kiwiliner}
HT-OSW Organic swing-over nozzle bodies (no non-drip)
HT-SPLIT4SEC 4 section spray ring, comes with swing-over nozzle bodies and one set of Albuz ATR’s supplied. For auto-rate or electric four section control, please check before ordering as extra cost is involved
HT-C218 2nd spray ring for Kiwiliner model only, comes with swing-over nozzle bodies and one set of Albuz ATR’s supplied.
For auto-rate four section control see option HT-HV2400-SOL4 above
B84.617.22 Triple roll-over nozzle bodies in lieu of double roll-over bodies, includes one set ATR nozzles

 

WHEEL OPTIONS

HT-HP202G 400 x 15.5 flotation tyres in lieu of standard tyre (Avoliner only) 

NOZZLES

2nd SET OF NOZZLES (text on order)
Albuz pink Ceramic disc & cores as second set of nozzles (one set of Albuz ATR conejets supplied with the sprayer) {For twin spray ring, allow a 2nd set}
A.I. nozzles 1 set (text on order) One set of Air Induction nozzles for HiCane application
HT-TG Top Gun assembly for Avoliner only, 2 x B64.610.69 long-throw adjustable nozzles per side. 1.5 nozzles standard.
Includes protective frame. For double-side spraying of tall tress to 10 metres

Reviews

There are no reviews yet.

Be the first to review “Kiwiliner 2000”

Your email address will not be published. Required fields are marked *

Call Now Button